- Notes, Cautions, and Warnings
- Working on Your Computer
- Removing and Installing Components
- Recommended Tools
- Removing the Cover
- Installing the Cover
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- Removing the Wireless Local Area Network (WLAN) Card
- Installing the WLAN Card
- Removing the Front Bezel
- Installing the Front Bezel
- Removing the Expansion Cards
- Installing the Expansion Card
- Memory Module Guidelines
- Removing the Memory
- Installing the Memory
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Speaker
- Installing the Speaker
- Removing the Power Supply
- Installing the Power Supply
- Removing the Heat Sink
- Installing the Heat-Sink Assembly
- Removing the Processor
- Installing the Processor
- Removing the System Fan
- Installing the System Fan
- Removing the Thermal Sensor
- Installing the Front Thermal Sensor
- Removing the Power Switch
- Installing the Power Switch
- Removing the Input/Output (I/O) Panel
- Installing the Input/Output Panel
- Removing the System Board
- System Board Components
- Installing the System Board
- System Setup
- Technology and Components
- Diagnostics
- Troubleshooting Your Computer
- Specifications
- Contacting Dell
Dell OptiPlex 9010/7010 Mini-Tower Owner's Manual
RAID BIOS Messages
This chapter provides more information on RAID BIOS Messages.
Non RAID Message
When the SATA Operation field in System Setup has been set toRAID On the system displays a RAID BIOS message after the Dell logo during POST. The message above is what is displayed if no RAID volume is created. As illustrated above any recognized hard drives will be displayed. Pressing <CTRL-I> consumer can enter RAID Configuration Utility control panel to execute some operations such as ´Create RAID Volume´
RAID 0 Message
A RAID 0 Stripe configuration displays a message as illustrated above just after the Dell logo screen during POST. Use the Port field to help identify a failed hard drive.
Array Capacity of RAID 0 : (Size of Smallest Drive * Number of Drives)
RAID 1 Message
A RAID 1 Mirror configuration displays a message as illustrated above just after the Dell logo screen during POST. Use the Port field to help identify a failed hard drive.
Array Capacity of RAID 1: Size of Smaller Drive
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\