Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge C6320p Owner's Manual

PDF

Installing the sensor board

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: You must route these cables properly on the chassis to prevent them from being pinched or crimped.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove all the hard drives.
  4. Remove the hard drive cage.
  5. Disconnect all the cables connected to the backplane and sensor board.
  6. Keep the Phillips #1 screwdriver ready.

Steps

  1. Install the sensor board into the sensor board holder and secure it with the screw.
  2. Connect the sensor board cable to the sensor board.
  3. Install the sensor board assembly into the hard drive cage.
  4. Insert the screws that secure the sensor board to the hard drive cage.
    Figure 1. Installing the sensor board
    This image shows installing the sensor board.
    Figure 2. Installing the sensor board assembly
    This figure shows installing the sensor board assembly.

Next steps

  1. Replace the hard drive cage into the chassis.
  2. Connect all the cables to the backplane.
  3. Connect the control panel cables to the power distribution board.
  4. Install the hard drives.
  5. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\