Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge C6320p Owner's Manual

Removing the SATA cable from the sled

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: Observe the routing of the cable as you remove it from the sled. Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the sled from the enclosure.
  4. Remove the air shroud.

Steps

  1. Open the cable retention lock to release the SATA cable.
  2. Press the clips on the cable connector to release the cable from the system board. Repeat this step with the connector on the other end of the cable.
  3. Lift the SATA cable out of the sled.
    Figure 1. Removing the SATA cable
    This figure shows removing the SATA cable

Next steps

  1. Install the SATA cable.
  2. Install the air shroud.
  3. Install the sled into the enclosure.
  4. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\