- Notes, cautions, and warnings
- Dell EMC PowerEdge C6420 overview
- Initial system setup and configuration
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- PERC battery
- Air shroud
- System memory
- Support bracket
- Linking board and PCIe cable
- Processor and heat sink module
- Removing a processor and heat sink module
- Installing a processor and heat sink module
- Removing the fabric processor from the processor heat sink module
- Installing the fabric processor into the processor heat sink module
- Removing the non-fabric processor from the processor and heat sink module
- Installing the non-fabric processor into a processor and heat sink module
- Removing the fabric and sideband cables
- Installing the fabric and sideband cables
- Expansion cards
- PCIe slot priority
- Removing the expansion card riser assembly
- Installing the expansion card riser assembly
- Removing an expansion card
- Installing an expansion card
- Removing the riser card
- Installing the riser card
- Removing the M.2 SATA x16 riser
- Installing the M.2 SATA x16 riser
- Removing the M.2 SATA card
- Installing the M.2 SATA card
- M.2 SSD module
- Mezzanine and OCP cards
- System battery
- System board
- Trusted Platform Module
- System diagnostics
- Jumpers and connectors
- Getting help
- Documentation resources
Dell EMC PowerEdge C6420 Installation and Service Manual
Removing a sled
Prerequisites
- Follow the safety guidelines listed in Safety Instructions.
NOTE For optimized thermal performance, see Sled installation guidelines.
NOTE The procedure to remove a sled blank
or a sled are the same.
Steps
Press the retaining latch and using the sled pull handle, slide the sled out
of the enclosure horizontally.Figure 1. Removing a sled 
Figure 2. Removing a sled
blank 
CAUTION Ensure that the sled is supported with both hands while it is being slid out.
CAUTION If you are permanently removing the sled, install a sled blank promptly. Operating the enclosure without a blank, for an extended time can result in overheating.
Next steps
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\