The following section describes the different functions
of the power button on your PowerEdge FX2/FX2s enclosure.
Chassis power button and chassis power button LED
The chassis power button is used to control power to the chassis
and the sleds. The chassis power button LED indicates the status of
power to the chassis and the sleds:
If the LED is OFF, power to the chassis and the sleds is turned
off.
If the LED is ON, power to the chassis and the sleds in turned
on.
Powering on the chassis and sleds
Press the chassis power button and the chassis power button LED
changes from OFF to ON. If pressing the chassis power button does
not change the power button LED from OFF to ON, see the troubleshooting
section.
Powering off the chassis and sleds
For a graceful shutdown of all the sleds and the chassis, press
and hold the chassis power button for 4 to 10 seconds and release
it.
NOTE: Depending
on the status of the sleds, graceful shutdown may not be possible.
You may opt for a forced shutdown by pressing and holding the chassis
power button for more than 10 seconds.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\