For faults
associated with sensors, such as temperature, voltage, fans, and so
on, the LCD message is automatically removed when that sensor returns
to a normal state. For other faults, you must take action to remove
the message from the display:
Clear the SEL — You can perform this task remotely, but you will
lose the event history for the system.
Power cycle — Turn off the system and disconnect it from the electrical
outlet; wait approximately 10 seconds, reconnect the power cable,
and restart the system.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\