- Notes, Cautions, and Warnings
- About your system
- Using the system Setup and Boot Manager
- Installing server
module components
- Recommended tools
- Installing and removing a server module
- Opening and closing the server module
- Inside The Server Module
- Cooling shroud
- System Memory
- PCIe mezzanine cards
- Management riser card
- SD vFlash card
- Network Daughter Card/LOM riser card
- Processors
- Hard Drives
- Hard-drive/SSD backplane
- System board
- NVRAM backup battery
- Storage controller card
- Troubleshooting your system
- Using system diagnostics
- Jumpers and connectors
- Technical Specifications
- System messages
- Getting help
Dell PowerEdge M620 Systems (For Dell PowerEdge VRTX Enclosure) Owner's Manual
Installing a server module
- If you are installing a new server module, remove the plastic cover from the I/O connector(s) and save for future use.
- Orient the server module so that the module handle is on the left side of the server module.
- Slide the server module into the enclosure until the module release handle engages and locks the server module in place.
- Reinstall the front bezel.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\