Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge MX740c Installation and Service Manual

PDF

Installing the M.2 BOSS card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your sled.

Steps

  1. Align the M.2 BOSS card at angle of 45 degrees with the SATA connector on the M.2 BOSS module.
  2. Press the M.2 BOSS card into the SATA connector until firmly seated in place.
  3. Push down the M.2 BOSS card and using Phillips #1 screwdriver, secure the M.2 BOSS card to the module.
    Figure 1. Installing the M.2 BOSS card
    This image shows installing the M.2 BOSS card

Next steps

  1. Install the M.2 BOSS module.
  2. Follow the procedure listed in the After working inside your sled.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\