Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge R230 Owner's Manual

Cooling fans

Depending on your system configuration, your system can support up to four cooling fans.

NOTE: : Hot swappable removal or installation of the fans is not supported.

NOTE: : Each fan is listed in the management software of the system, referenced by the respective fan number. If there is a problem with a particular fan, you can easily identify and replace the proper fan by noting down the fan numbers provided on the cooling fans.

The following table shows the number of fans required for different system configurations:

NOTE: : Ensure that you install a cooling fan blank in an empty cooling fan bracket.

Table 1. Number of fans based on system configurationSystems with four 3.5-inch hot swappable or cabled hard drives and expansion cards support four cooling fans. Systems with four 3.5-inch hot swappable or cabled hard drives and without expansion cards support three cooling fans. Systems with two 2.5-inch cabled hard drives and expansion cards support three cooling fans. Systems with two 2.5-inch cabled hard drives and without expansion cards support two cooling fans.
System configuration Number of fans
Systems with four 3.5-inch hot swappable or cabled hard drives and expansion card 4
Systems with four 3.5-inch hot swappable or cabled hard drives and without expansion card 3
Systems with two 2.5-inch cabled hard drives and expansion card 3
Systems with two 2.5-inch cabled hard drives and without expansion card 2

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\