Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R640 Installation and Service Manual

PDF

Removing the network daughter card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in After working inside your system.
  3. Remove the expansion card riser 2 or the rear drive cage, depending on the configuration of your system.

Steps

  1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
  2. Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
  3. Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
    Figure 1. Removing the network daughter card
    This image shows removing the network daughter card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\