Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge R720 and R720xd Owner's Manual

Installing The Network Daughter Card

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Angle the card so that the RJ-45 connectors fit through the slot in the back panel.
  2. Align the captive screws at back-end of the card with the captive screw sockets on the system board.
  3. Press the touch point on the card until the card connector is firmly seated on the system board connector.
  4. Using a #2 Phillips screwdriver, tighten the two captive screws to secure the network daughter card to the system board.
  5. If applicable, install the expansion card(s) in the expansion-card riser 2.
  6. Close the system.
  7. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\