Navigate to
Intel Persistent Memory > Region Configuration > Create Goal Config.
Change Persistent percentage as 100% to configure Intel PMem into 100% App-direct Mode and 0% to configure the DIMMs into 100% memory mode.
NOTE The
Persistent memory type field is for configuring a new goal. It is not for reading the status of the current goal. Use instructions under
PMem Hardware Status to confirm current configuration.
Click Apply and reset the system.
Goals will be applied into operating modes (either App-direct or Memory) in the next power cycle.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\