Dell PowerEdge RAID Controller 9 User’s Guide H330, H730, and H830

Replacing the battery of a H730P mini monolithic card

1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
   NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
2. Open the system.
3. Locate the PERC card on the system board.
4. Remove the PERC card. For more information, see Removing the HBA330 mini monolithic controller.
5. Disconnect the battery cable from the PERC card.
6. Pull the battery carrier until the tabs on the battery carrier disengage from the PERC card.

   

   1. PECR H730P mini monolithic card
   2. battery
   3. tab on the battery carrier (3)
   4. battery cable

7. Pull the battery out of the battery carrier.

   

   1. battery carrier
   2. guide on the battery carrier (2)
   3. battery
   4. battery cable

8. Align the replacement battery with the guides on the battery carrier.
9. Lower the battery into the carrier until the battery clicks into place.
10. Align the tabs on the battery carrier with the slots on the PERC9 mini monolithic controller and lower the battery carrier till it clicks into place.
11. Connect the battery cable to the PERC card.
12. Replace the PERC card. For more information, see Installing the HBA330 mini monolithic controller.
13. Close the system.
14. Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.