Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T30 Owner's Manual

PDF

Removing the power supply unit

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

Steps

  1. Disconnect the P1 and P2 power cables from the power supply unit (PSU) to the system board connectors.
  2. Remove the screws securing the PSU to the chassis.
  3. Press the release tab beside the power supply unit, and slide the PSU towards the front of the system.
  4. Lift the PSU out of the system.
    Figure 1. Removing the power supply unit
    This figure shows removing the power supply unit.

Next steps

  1. Install the power supply unit.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\