Removing a 3.5-inch
hard drive carrier from the hard drive cage
Prerequisites
CAUTION: Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Follow the safety
guidelines listed in the Safety instructions section.
Follow the procedure
listed in the Before working inside your system section.
If applicable, disconnect the power and data cables
from the hard drive in the hard drive cage.
Remove the hard drive cage.
Steps
Press the retention clips inwards and pull
the hard drive out of the hard drive cage.
Figure 1. Removing a 3.5-inch
hard drive carrier from the hard drive cage
Next steps
Install the 3.5-inch hard drive carrier
in the hard drive cage.
Follow the procedure
listed in the After working inside your system section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
