- Notes, cautions, and warnings
- Introducing your Dell DL1000
- Installing your Dell DL1000
- Configuring your Dell DL1000
- Preparing to
protect your servers
- Installing agents on clients
- About installing the Agent software on Linux machines
- Installing the Agent software on offline Linux machines
- Protecting a machine
- Getting help
Dell DL1000 Appliance Deployment Guide
Checking network connectivity
- On the client system to which you are trying to connect, open a command line interface.
- Run the command ipconfig and note the IP address of the client.
- Open a command line interface on the appliance.
- Run the command ping <IP address of client> .
-
Depending on the result, do one of the following:
- If the client does not reply to the ping, verify the server’s connectivity and network settings.
- If the client replies, check that the firewall settings allow the DL1000 components to run.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\