NOTE: Your computer’s Service Tag is located under the system badge flap.
You must enter the Service Tag in the BIOS after you replace the system
board.
NOTE: Before disconnecting the cables from the system board, note the location
of the connectors so that you can re-connect them correctly after
you replace the system board.
Remove the M2x2 screw securing the metal bracket
for the LVDS to the system board [1] and remove the bracket off the
computer [2]. Then, disconnect the LVDS cable from the system board
[3].
Slide out the connector latches to disconnect
all the cables from the system board.
Perform the following steps to remove the system
board from the computer:
Remove the five M2x4 screws that secure
the system board to the computer [1].
Lift the system board off the computer [2].
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\