- Working on your computer
- Removing and
installing components
- Removing the Secure Digital (SD) card
- Installing the SD card
- Removing the battery cover
- Installing the battery cover
- Removing the battery
- Installing the battery
- Removing the base cover
- Installing the base cover
- Removing the hard drive
- Installing the hard drive
- Removing the keyboard
- Installing the keyboard
- Removing the secondary memory
- Installing the secondary memory
- Removing the primary memory
- Installing the primary memory
- Removing Wireless Wide Area Network (WWAN) card (Optional)
- Installing the WWAN card (Optional)
- Removing the Wireless Local Area Network (WLAN) card
- Installing the WLAN Card
- Removing the M.2 Solid State Drive (SSD)
- Installing the M.2 SSD
- Removing the coin cell battery
- Installing the coin cell battery
- Removing the hard drive cable
- Installing the hard drive cable
- Removing the power connector port
- Installing the power connector port
- Removing the palmrest
- Installing the palmrest
- Removing the speakers
- Installing the speakers
- Removing the Input/Output (I/O) board left
- Installing the I/O board left
- Removing the Input/Output (I/O) board right
- Installing the I/O board right
- Removing the heat sink assembly
- Installing the heat sink assembly
- Removing the video card
- Installing the video card
- Removing the display assembly
- Installing the display assembly
- Removing the display bezel
- Installing the display bezel
- Removing the camera
- Installing the camera
- Removing the system board
- Installing the system board
- Removing the LED board
- Installing the LED board
- System setup
- Diagnostics
- Troubleshooting your computer
- Specifications
- Contacting Dell
Dell Precision 17 7000 series (7710) Owner's Manual
Installing the display assembly
- Tighten the screws to secure the display assembly in place.
- Affix the tape on the heat pipe.
- Connect the eDP cable to the correct connectors on the system board.
- Insert the wireless antenna cables through the routing hole on the chassis.
- Tighten the screws at the bottom and back of the computer.
- Align the display hinge cap and tighten the screws to secure it to the computer.
- Route and connect the antenna cables to their connectors.
- Install the:
- Follow the procedure in After working inside your computer
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\