Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC NX430 System Owner's Manual

System board jumper settings

For information about resetting the password jumper to disable a password, see the Disabling a forgotten password section.
Table 1. System board jumper settings . The table describes the system board jumper settings.
JumperSettingDescription
PWRD_ENThe figure shows jumper pin settings when the password feature is enabled. (default) The password feature is enabled (pins 4–6).
 The figure shows jumper pin settings when the password feature is disabled.The password feature is disabled (pins 2–4). iDRAC local access is unlocked at the next AC power cycle.
NVRAM_CLRThe figure shows jumper pin settings when the configuration settings are retained at system boot (default) The configuration settings are retained at system boot (pins 1–3).
 The figure shows jumper pin settings when the configuration settings are cleared at the next system bootThe configuration settings are cleared at the next system boot (pins 3–5).

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\