Dell Storage Center SCv2000 and SCv2020 Storage System Deployment Guide

Configure the embedded Ethernet ports on the Storage Center for use as iSCSI ports.

1. If the Flex Port license is installed, configure the fault domain and ports for Flex Port Domain 1.
   
   
   • NOTE: The Flex Port feature allows both Storage Center system management traffic and iSCSI traffic to use the same physical network ports. However, for environments where the Storage Center system management ports are mixed with network traffic from other devices, separate the iSCSI traffic from management traffic using VLANs.
   1. Enter the target IPv4 address, subnet mask, and gateway for the fault domain.
   2. Enter an IPv4 address for each port in the fault domain.
   • NOTE: Make sure that all the IP addresses for Flex Port Domain 1 are in the same subnet.
2. Configure the fault domain and ports for iSCSI Embedded Domain 2.
   1. Enter the target IPv4 address, subnet mask, and gateway for the fault domain.
   2. Enter an IPv4 address for each port in the fault domain.
   • NOTE: Make sure that all the IP addresses for iSCSI Embedded Domain 2 are in the same subnet.
3. Click OK.