Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Vostro 15 7510 Service Manual

PDF

Installing the power-adapter port

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the power-adapter port and provides a visual representation of the installation procedure.

Installing the power-adapter port

Steps

  1. Place the power-adapter port, along with its cable, into the slot on the palm-rest and keyboard assembly.
  2. Route the power-adapter port cable through the routing guide on the palm-rest and keyboard assembly.
  3. Adhere the tapes that secure the power-adapter port cable to the system board.
  4. Connect the power-adapter port cable to the system board.
  5. Close the right display-hinge and align the screw holes on the right display-hinge with the screw holes on the system board and palm-rest and keyboard assembly.
  6. Replace the two (M2.5x5) screws that secure the right display-hinge to the system board and palm-rest and keyboard assembly.

Next steps

  1. Install the heat sink.
  2. Install the base cover.
  3. Exit Service Mode.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\