Dell Wyse ThinOS Version 8.5 and ThinOS Lite 2.5 Operating System Release Notes

DisplayPort audio is supported on DP1 and DP2.

• To enable the DisplayPort audio on ThinOS:
  1. Set up a monitor with DP audio support.
  2. Connect the ThinOS client to monitor using DP cable.
  3. Plug the analog headset into the monitor DP audio interface.
  4. On the ThinOS desktop, click System Setup > Peripherals > Audio > Playback devices, and select the Enable DP audio check box.
  5. Start either an RDP, ICA, PCoIP, or Blast session.
  6. Play a video, and check the audio output using the analog headset.
     Figure 1. Audio
• Analog Headset Popup

  Select the Enable headset popup check box to display the headset popup dialog box when you connect an analog headset to the front audio jack.

  In the headset popup dialog box, select any one of the following audio devices:

  • Headset
  • Headphone
  • Speaker
  • NOTE: To disable the headset popup dialog box, select the Not show again check box. You can also use an INI parameter to enable or disable the headset popup dialog box. For more information about the INI parameter, see INI parameters.

For the list of known issues about the DisplayPort audio, see Known issues.