Before you begin the pull operation, ensure that your device is configured to boot from the USB drive.
Steps
Plug in the USB drive to the supported source device.
To access the boot menu, reboot the device, and keep pressing either the
P key or
F12 key during system reboot depending on your thin client model; To select the boot menu function key (P or F12) for your thin client model, see
Boot details for supported devices.
The boot options are displayed, and you can see either of the following boot menu screens depending on your thin client model:
Select the USB option displaying your USB drive vendor name and press Enter.
NOTE You will be prompted to enter the BIOS password. You shall reach out to the sales Engineer for the default BIOS password.
The device reboots from the USB drive, and the image that is to be pushed to the device is displayed.
In the left pane, the following information is displayed:
Device info—Displays information such as platform, media, and system of the target device.
USB drive—Displays information such as used space, free space, and total space of the USB drive.
In the
Choose image to push to this device section, select the local image from the list, and click
OK.
The image push operation starts, and the overall status is displayed in the progress bar.
After both operating system and BIOS push operations are complete, remove the USB drive from the target device.
To reboot the device, click
Restart.
NOTE Wyse 5060 thin client and Wyse 3030 LT thin client restart automatically after BIOS push operation is complete.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\