- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
XPS 15 9500 Service Manual
Installing the solid-state drive 2
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
About this task
The following image indicates the location of the solid-state drive 2 and provides a visual representation of the installation procedure.
Steps
- Align the notch on the solid-state drive 2 with the tab on the solid-state drive slot.
- Gently slide the solid-state drive 2 into the solid-state drive slot.
- Slide the solid-state drive thermal bracket into the alignment post on the system board.
- Align the screw hole on the solid-state drive thermal bracket with the screw hole on the system board.
NOTE: The size of the solid-state drive thermal bracket varies based on the storage type. A solid-state drive thermal bracket that is designed for an M.2 2280 drive cannot accommodate an M.2 2230 drive and vice versa.
- Replace the screw (M2x2) that secures the solid-state drive thermal bracket and the solid-state drive 2 to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\