- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the hard drive
- Replacing the hard drive
- Removing the solid-state drive (half-length)
- Replacing the solid-state drive (half-length)
- Removing the solid-state drive (full-length)
- Replacing the solid-state drive (full-length)
- Removing the speakers
- Replacing the speakers
- Removing the wireless card
- Replacing the wireless card
- Removing the fans
- Replacing the fans
- Removing the heat-sink assembly
- Replacing the heat-sink assembly
- Removing the memory modules
- Replacing the memory modules
- Removing the system board
- Replacing the system board
- Removing the audio daughter board
- Replacing the audio daughter board
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the keyboard
- Replacing the keyboard
- Removing the display assembly
- Replacing the display assembly
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the antenna cover
- Replacing the antenna cover
- Removing the display hinges
- Replacing the display hinges
- Removing the antenna module
- Replacing the antenna module
- Removing the palm-rest assembly
- Replacing the palm-rest assembly
- Flashing the BIOS
- Getting help and contacting Dell
XPS 15 Service Manual
Procedure
- Align the screw holes on the processor fan (JFAN_1) with the screw holes on the palm-rest assembly.
- Connect the processor fan (JFAN_1) cable to the system board.
- Route the display cable through the routing guides on the processor fan (JFAN_1).
- Replace the screws that secure the processor fan (JFAN_1) to the system board.
- Align the screw holes on the video fan (JFAN_2) with the screw holes on the palm-rest assembly.
- Connect the video fan (JFAN_2) cable to the system board.
- Route the touch-screen cable through the routing guides on the video fan (JFAN_2).
- Adhere the tape that secures the touch-screen cable to the video fan (JFAN_2).
- Connect the display cable to the system board.
- Replace the screws that secure the video fan (JFAN_2) to the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\