XPS 15 2-in-1 Service Manual

Procedure

1. Open the latch and disconnect the camera cable from the system board.
2. Peel the camera cable from the palm-rest and keyboard assembly.
3. Peel the tape that secures the display-cable bracket to the system board.
4. Remove the two screws (M1.6x1.8) that secure the display-cable bracket to the system board and lift the bracket off the system board.
5. Using the pull tab, disconnect the display cable from the system board.
6. Remove the two screws (M2x4) that secure the wireless-antenna bracket to the I/O board and lift the bracket off the I/O board.
7. Disconnect the antenna cables from the I/O board.
   
8. Open the computer at a 180-degree angle and place it on a flat and clean surface with the display screen facing down.
9. Remove the six screws (M2.5x4) that secure the display assembly to the palm-rest and keyboard assembly.
10. Lift the display assembly from the palm-rest assembly.