Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge T630 Owner's Manual

PDF

Installing a flex bay

Prerequisites

  1. Follow the safety guidelines listed in the safety instructions section.
  2. Keep the Phillips #2 screwdriver ready.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Align the tabs on the flex bay with the slots on the front of the chassis.
  2. Insert the flex bay into the chassis until the tabs click into place.
  3. Install the two screws to secure the flex bay to the chassis.

Next steps

Follow the procedure listed in the After working inside your system section.

Figure 1. Installing a flex bay
This figure shows Installing a flex bay.
  1. flex bay
  2. tab (3)
  3. screw hole (2)
  4. release latch
  5. screw (2)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\