Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge T630 Owner's Manual

PDF

Removing caster wheels

Prerequisites

  1. Follow the safety guidelines listed in the safety instructions section.
  2. Keep the Phillips #2 screwdriver ready.
  3. Place the system on a flat, stable surface with the wheels extending beyond the edge of the surface.

Steps

  1. Remove the screw that secures the front wheel unit to the base of the chassis.
  2. Offset the front wheel unit slightly to the back of the system to release the retention hooks, and pull out the front wheel unit.
  3. Remove the screw that secures the back wheel unit to the base of the chassis.
  4. Offset the back wheel unit slightly to the front of the system to release the retention hooks, and pull out the back wheel unit.
    Figure 1. Removing caster wheels
    This figure shows Removing caster wheels.
    1. slots on base of the tower (4)
    2. wheel assembly unit (2)
    3. screw (2)

    4. screw for support unit (2)

    5. support unit

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\