Installing a
hot swappable hard drive into a hot swappable hard drive carrier
Prerequisites
CAUTION: Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE: Hot swappable
hard drives are supplied in hot swappable hard drive carriers that
fit in the hard drive slots.
Keep the Phillips #2 screwdriver
ready.
Remove the
hot swappable hard drive carrier.
Steps
Insert the hot swappable hard drive into the hard drive carrier with
the connector end of the hard drive toward the back.
Align the screw holes on the hard drive with the set of screw holes
on the hard drive carrier.
When aligned correctly, the back of the hard drive
is flush with the back of the hard drive carrier.
Attach the screws to secure the hard drive to the hard drive carrier.
Next steps
Install the hard drive carrier into the system.Figure 1. Installing a
hot swappable hard drive into a hot swappable hard drive carrier
screw (4)
hard drive
hard drive carrier
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
