Dell Chassis Management Controller Version 1.3 for PowerEdge FX2/FX2s RACADM Command Line Reference Guide

Description

Sets the state (blinking or not blinking) of the LED on the specified module.

To blink or unblink the chassis, I/O modules or the CMC, you must have the Debug Administrator privilege on CMC. To enable the servers to blink or unblink, you must have the Server Administrator or Debug Administrator privilege on CMC.

Synopsis

racadm setled -m <
                                                module> -l <
                                                ledState>
                                             

Input

• -m < module> - Specifies the module whose LED you want to configure.

  < module> can be one of the following:

  — server-n, where n=1–4

  — switch-n, where n=1–2

  — cmc-active

  — chassis

• -l < ledstate> - Specifies whether the LED should blink.

  < ledstate> can be one of the following:

  – 0 — no blinking

  – 1 — blinking

Example

• racadm setled -m server-1 -1 1

  LED state was set successfully.

• racadm setled -m server-9 -1 1

  ERROR: Server in slot 9 is an extension of the server in slot 1.