Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

cam-optimization

Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.

Syntax

cam-optimization [qos]

Parameters

qos	Optimize CAM usage for QoS.

Defaults

Disabled.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

When you enable this command, if a Policy Map containing classification rules (ACL and/or dscp/ ip-precedence rules) is applied to more than one physical interface on the same port pipe, only a single copy of the policy is written (only one FP entry is used).

NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of interfaces. For more information, refer to the IP Access Control Lists, Prefix Lists, and Route-mapsections in the Dell Networking Operating System Configuration Guide .