Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge C4130 Owner's Manual

PDF

Installing a GPU

Your system supports up to four GPUs.

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the GPU installation guidelines.
  3. Install the GPU brackets.
  4. Install the GPU riser cable board.

Steps

  1. Lower the front of the GPU at an angle and slide it to engage the slots on the GPU with the guide pins on the front inner wall of the chassis.

    NOTE: Do not hold the GPU by the GPU riser cable board.

    CAUTION: While installing the GPU, ensure that the guide pins on the chassis do not scrape the GPU.

  2. Lower the back of the GPU to engage the guide holes on the GPU with the guide pins on the chassis.
  3. Connect the GPU power cables to the GPU and the system board or the switch board.
    Figure 1. Installing the GPU
    This figure shows installing of a GPU.
    1. guide pin on the front inner wall of the chassis (2)
    2. GPU 2
    3. slot on the GPU I/O bracket (2)
    4. GPU 1
    5. guide hole on the GPU support bracket
    6. GPU riser cable
    7. GPU connector on the system board or on the switch board
    8. guide pin on the chassis (2)
    9. GPU riser cable board

Next steps

CAUTION: The GPU should be installed in the system before installing the GPU riser cables to prevent pin damage in the PCIe connectors on the system board or switch board.

  1. If required, install the GPU blank.
  2. Install the GPU riser cable to the system board.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"