Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Configuration Cloning

Configuration Cloning enables you to clone the configuration from one aggregator to one or more aggregators. You can identify the source aggregator where running configuration is check-pointed, extracted and downloaded to the target aggregator for further use. The target aggregator checks the compatibilities of the cloning file based on the version, mode and optional modules. The target aggregator further takes care of the conflicting configurations and appropriately proceeds with the application of the cloning configuration. Select the source or target aggregator and run the CLI commands to achieve the cloning operation and verify the CLI output to check the status of the command execution. By default, the aggregator is enabled with SCP server, so that you can make necessary transfers of cloning configuration file. You can also confirm the configuration status of server using the show ip ssh command before proceeding to file transfer. The aggregator takes care of the conflicting configurations between the source aggregator and target aggregator and appropriately informs you to perform the necessary action.

To configure a cloning operation on an aggregator, follow these general configuration steps:

  1. Create the cloning configuration in the source aggregator.

    clone-config create [file-name filename][output xml] 

    Dell#clone-config create filename standalone_combo_card
                                          SUCCESS:Cloning configuration created successfully(13)
                                          Dell#

  2. Check the cloning configuration file compatibility with the current configurations on the target aggregator. The command expects the file specified in the command to be already present in local file system (flash:).

    clone-config check [file-name filename][output xml] 

    WARNING:Release Patch version mismatch(20); 
                                          Release time mismatch(21); 
                                          Release size mismatch(22);
                                          FC ports have to be reconfigured to Ethernet ports.(28)
                                          NumRebootsRequired : 1

  3. Add the command usage in the target aggregator.

    clone-config apply [file-name filename][output xml] 

    Dell#clone-config apply filename standalone_combo_card
                                          Jul 23 15:08:11: %STKUNIT0-M:CP %CFGCLONING-1-CFGCLONING_INFO_RELOAD: Reloading device to apply cloning configuration
                                          Jul 23 15:08:11: %STKUNIT0-M:CP %CHMGR-5-RELOAD: User request to reload the chassis

By default, if the filename is not specified in CLI, the file used for the cloning operation is cloning-config.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"