Omitir para ir al contenido principal
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Establish Sessions with VLAN Neighbors

To establish a session, enable BFD at interface level on both ends of the link, as shown in the following illustration. The session parameters do not need to match.

Figure 1. Establishing Sessions with VLAN Neighbors Illustration of establishing sessions with VLAN neighbors.

To establish a BFD session with a VLAN neighbor, follow this step.

Establish sessions with a VLAN neighbor. INTERFACE VLAN mode bfd neighbor ip-address
View the established sessions using the show bfd neighbors command, as shown in the following example.
R2(conf-if-vl-200)#bfd neighbor 2.2.3.2
                                 R2(conf-if-vl-200)#do show bfd neighbors
                                 
                                 * - Active session role
                                 Ad Dn - Admin Down
                                 C - CLI
                                 I - ISIS
                                 O - OSPF
                                 R - Static Route (RTM)
                                 V - VRRP
                                 
                                 LocalAddr RemoteAddr Interface State Rx-int Tx-int Mult Clients
                                 * 2.2.3.2 2.2.3.1    
                                 Vl 200    Up    200    200    3    C
                              

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"