Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

You can reset the configurations applied on an interface to its factory default state. To reset the configuration, perform the following steps:

1. View the configurations applied on an interface. INTERFACE mode show config

    Dell(conf-if-te-1/5)#show config 
                                       !
                                       interface TenGigabitEthernet 1/5
                                       no ip address
                                       portmode hybrid
                                       switchport
                                       rate-interval 8
                                       mac learning-limit 10 no-station-move
                                       no shutdown
                                       
                                    

2. Reset the interface to the factory default state. CONFIGURATION mode default interface interface-type slot/port

   Dell(conf)#default interface tengigabitethernet 1/5

3. Verify the configuration. INTERFACE mode show config

   Dell(conf-if-te-1/5)#show config 
                                       !
                                       interface TenGigabitEthernet 1/5
                                       no ip address
                                       shutdown
                                    

   All the applied configurations are removed and the interface is set to the factory default state.