- Notes, cautions, and warnings
- Working on Your Computer
- Removing and
Installing Components
- Recommended Tools
- System Overview
- Removing the Battery
- Installing the Battery
- Removing the SD Card
- Installing the SD Card
- Removing the ExpressCard
- Installing the ExpressCard
- Removing the SIM Card
- Installing the SIM Card
- Removing the Display Bezel
- Installing the Display Bezel
- Removing the Display Panel
- Installing the Display Panel
- Removing the Camera
- Installing the Camera
- Removing the Keyboard Trim
- Installing the Keyboard Trim
- Removing the Keyboard
- Installing the Keyboard
- Removing the Base Cover
- Installing the Base Cover
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Memory Module
- Installing the Memory Module
- Removing the WLAN Card
- Installing the WLAN Card
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Display Hinge
- Installing the Display Hinge
- Removing the Palmrest
- Installing the Palmrest
- Removing the Display Assembly
- Installing the Display Assembly
- Removing the ExpressCard Cage
- Installing the ExpressCard Cage
- Removing the System Fan
- Installing the System Fan
- Removing the System Board
- Installing the System Board
- Removing the Heatsink
- Installing the Heatsink
- Removing the I/O Board (Left)
- Installing the I/O Board (Left)
- Removing the I/O Board (Right)
- Installing the I/O Board (Right)
- Removing the Power Connector
- Installing the Power Connector
- Removing the Speakers
- Installing the Speakers
- Removing the Status-Light Board
- Installing the Status-Light Board
- System Setup
- Diagnostics
- Specifications
- Contacting Dell
Dell Latitude E5440 Series Owner's Manual
Installing the System Board
- Align the system board into its original position on the computer.
- Replace and tighten the screws to secure the system board to the computer.
-
Connect the following cables:
- I/O board cable
- power-connector cable
- status-light board cable
- Turn over the computer and connect the coin-cell battery cable and speaker cable to the system board.
-
Install:
- ExpressCard cage
- system fan
- palmrest
- display hinge
- WLAN card
- hard drive
- optical drive
- memory
- keyboard
- keyboard trim
- base cover
- battery
- SD card
- Follow the procedures in After Working Inside Your Computer.
Anna arvioinnit (1–5 tähteä).
Anna arvioinnit (1–5 tähteä).
Anna arvioinnit (1–5 tähteä).
Valitse, oliko artikkelista mielestäsi hyötyä vai ei.
Kommenteissa ei voi olla seuraavia erikoismerkkejä: <>()\