Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

To configure match criterion for a route map, use the following commands.

• Match routes whose next hop is a specific interface. CONFIG-ROUTE-MAP mode match interface interface

  The parameters are:

  • For a Loopback interface, enter the keyword loopback then a number between zero (0) and 16383.
  • For a 10-Gigabit Ethernet interface, enter the keyword tengigabitEthernet then the slot/port information.
  • For a VLAN, enter the keyword vlan then a number from 1 to 4094.
• Match destination routes specified in a prefix list (IPv4). CONFIG-ROUTE-MAP mode match ip address prefix-list-name
• Match next-hop routes specified in a prefix list (IPv4). CONFIG-ROUTE-MAP mode match ip next-hop { access-list-name | prefix-list prefix-list-name}
• Match source routes specified in a prefix list (IPv4). CONFIG-ROUTE-MAP mode match ip route-source { access-list-name | prefix-list prefix-list-name}
• Match routes with a specific value. CONFIG-ROUTE-MAP mode match metric metric-value
• Match routes specified as internal or external to OSPF, ISIS level-1, ISIS level-2, or locally generated. CONFIG-ROUTE-MAP mode match route-type {external [type-1 | type-2] | internal | level-1 | level-2 | local }
• Match routes with a specific tag. CONFIG-ROUTE-MAP mode match tag tag-value