Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

CLI Command Mode	Prompt	Access Command
EXEC	`Dell>`	Access the router through the console or Telnet.
EXEC Privilege	`Dell#`	From EXEC mode, enter the `enable` command. From any other mode, use the `end` command.
CONFIGURATION	`Dell(conf)#`	From EXEC privilege mode, enter the `configure` command. From every mode except EXEC and EXEC Privilege, enter the `exit` command.
NOTE: Access all of the following modes from CONFIGURATION mode.
10 Gigabit Ethernet Interface	`Dell(conf-if-te-0/1)#`	`interface` (INTERFACE modes)
Interface Range	`Dell(conf-if-range)#`	`interface` (INTERFACE modes)
Management Ethernet Interface	`Dell(conf-if-ma-0/0)#`	`interface` (INTERFACE modes)
MONITOR SESSION	`Dell(conf-mon-sess)#`	`monitor session`
CONSOLE	`Dell(config-line-console)#`	`line` (LINE Modes)
VIRTUAL TERMINAL	`Dell(config-line-vty)#`	`line` (LINE Modes)

Navigating CLI Modes