Dell PowerEdge T20 Owner's Manual

Installing The Thermal Sensor

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
Lay the system on its side, on a flat and stable surface.
Open the system.
Align the tabs with the thermal-sensor slot on the chassis and secure the thermal sensor to the chassis.
Route the thermal-sensor cable through the chassis clip and connect the thermal-sensor connector to the system board.
Close the system.
Place the system upright on a flat, stable surface.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.