メイン コンテンツに進む
  • すばやく簡単にご注文が可能
  • 注文内容の表示、配送状況をトラック
  • 会員限定の特典や割引のご利用
  • 製品リストの作成とアクセスが可能
  • 「Company Administration(会社情報の管理)」では、お使いのDell EMCのサイトや製品、製品レベルでのコンタクト先に関する情報を管理できます。

Dell PowerEdge T20 Owner's Manual

Removing the system board

  • CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may be prompted to create a recovery key during program or system setup. Be sure to create and safely store this recovery key. If you replace this system board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on your hard drives.
  1. Remove the following:
    1. system fan
    2. all expansion cards
    3. heat sink and processor
    4. memory modules
  2. Disconnect all the cables from the system board.
  1. Remove the eight screws that secure the system board to the chassis.
  2. Hold the system board by the sides, slide the system board towards the front of the system and lift the system board out.
    Figure 1. Removing the System Board The figure shows removing and installing the system board.
    1. screws (8)
    2. system board
  1. Install the system board.
  2. Connect all the cables to the system board.

このコンテンツを評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
0/3000 characters
  1~5個の星の数で評価してください。
  1~5個の星の数で評価してください。
  1~5個の星の数で評価してください。
  この記事は役に立ちましたか?
  コメントでは、以下の特殊文字は利用できません: <>()\