Table shown here contains the supported options
used for RDP connections after you use the Connect=RDP parameter/selection.
NOTE:
If an option has an underlined value (default), that
option and default value will automatically be used with Connect=RDP;
options without underlined values can also be used if you want to,
but are not automatically used with Connect=RDP. In addition, when
using options, you can leave the default value or change it to another
value shown.
For example, in the following case
where:
Connect=RDP
[Option1={0, 1}]
[Option2={1, 2, 3, 4}]
Since you are using Connect=RDP, then Option 1 and
its default value 0 will automatically be used as Option1 has an underlined
value (default of 0). You can still use Option 2 if you want to, however,
Option 2 is not automatically used with the parameter as Option 2
does not have a default (underlined) value.
NOTE:
Any option in RDP Connect Options that is used in a {username}.ini file will return to the default
value set for that option in the wnos.ini file after a user sign-off.
For example, if your {username}.ini
file contains the option Reconnect=yes (so that a lost connection
will restart 20 seconds after disconnection) and you sign off of the
thin client, then the Reconnect value will return to the original
default value of no (Reconnect=no) contained in the wnos.ini file—so
that others who sign in can use their own user profile assuming the
administrator has not changed the default values in the wnos.ini file.