- Notes, cautions, and warnings
- Copyright
- About your system
- Using The System Setup And Boot Manager
- Installing System
Components
- Recommended Tools
- Opening And Closing The System
- Bezel
- Chassis intrusion switch
- Inside the system
- Thermal Sensor
- Power switch
- Input/Output (I/O) panel
- Hard drives
- Removing the hard drive cage
- Installing the hard drive cage
- Removing a 3.5-inch hard drive carrier from the hard drive cage
- Installing a 3.5-inch hard drive carrier in the hard drive cage
- Removing a 2.5-inch hard drive(s) from the optical drive bay
- Installing a 2.5-inch hard drive(s) in the optical drive bay
- Removing a 3.5-inch hard drive carrier from the hard drive bay
- Installing a 3.5-inch hard drive carrier in the hard drive bay
- Removing A Hard Drive From A Hard-Drive Carrier
- Installing A Hard Drive Into A Hard-Drive Carrier
- Optical drive
- System memory
- Sample memory configurations
- System fan
- Expansion cards
- Processors
- Power supply unit
- System Battery
- System board
- Troubleshooting
your system
- Power LED Diagnostics
- Memory Beep Code
- Troubleshooting System Startup Failure
- Troubleshooting external connections
- Troubleshooting the video subsystem
- Troubleshooting a USB device
- Troubleshooting a serial I/O device
- Troubleshooting A NIC
- Troubleshooting A Wet System
- Troubleshooting A Damaged System
- Troubleshooting the system battery
- Troubleshooting A Non-Redundant Power Supply
- Troubleshooting cooling problems
- Troubleshooting The System Fan
- Troubleshooting System Memory
- Troubleshooting An Optical Drive
- Troubleshooting A Hard Drive
- Troubleshooting Expansion Cards
- Troubleshooting The Processor
- Using System Diagnostics
- Jumpers and connectors
- Technical Specifications
- System Messages
- Getting help
Dell PowerEdge T20 Owner's Manual
Closing The System
- Ensure that all internal cables are connected and placed out of the way and that no tools or extra parts are left inside the system.
- Align the tabs on the system cover with the corresponding slots on the system chassis.
- Lower the system cover onto the chassis until it clicks into place.
- Place the system upright on a flat, stable surface.
- Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\