Integrated Dell Remote Access Controller 9 Version 3.15.15.15 User's Guide

PDF

Configuring iDRAC to use SOL using RACADM

To configure IPMI Serial over LAN (SOL):

Enable IPMI Serial over LAN using the command.
```
racadm set iDRAC.IPMISol.Enable 1
```
Update the IPMI SOL minimum privilege level using the command.
```
racadm set iDRAC.IPMISol.MinPrivilege <level>
```
Parameter Privilege level
<level> = 2 User
<level> = 3 Operator
<level> = 4 Administrator
NOTE:To activate IPMI SOL, you must have the minimum privilege defined in IMPI SOL. For more information, see the IPMI 2.0 specification.
Update the IPMI SOL baud rate using the command.
```
racadm set iDRAC.IPMISol.BaudRate <baud_rate>
```
NOTE:To redirect the serial console over LAN, make sure that the SOL baud rate is identical to the managed system’s baud rate.
Parameter Allowed values (in bps)
<baud_rate> 9600, 19200, 57600, and 115200.
Enable SOL for each user using the command.
```
racadm set iDRAC.Users.<id>.SolEnable 2
```
Parameter Description
<id> Unique ID of the user

NOTE:To redirect the serial console over LAN, ensure that the SOL baud rate is identical to the baud rate of the managed system.