Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

Dell PowerEdge R330 Owner's Manual

PDF

Installing a heat sink

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Install the processor.
  4. Keep the Phillips #2 screwdriver ready.

Steps

  1. If you are using an existing heat sink, remove the thermal grease from the heat sink by using a clean lint-free cloth.
  2. Use the thermal grease syringe included with your processor kit to apply the grease in a thin spiral on the top of the processor.

    CAUTION: Applying too much thermal grease can result in excess grease coming in contact with and contaminating the processor socket.

    NOTE: The thermal grease syringe is intended for one-time use only. Dispose of the syringe after you use it.

    Figure 1. Applying thermal grease on the top of the processor
    This figure shows applying thermal grease on the top of the processor.
    1. processor
    2. thermal grease
    3. thermal grease syringe
  3. Place the heat sink onto the processor.
  4. Tighten one of the four screws to secure the heat sink to the system board.
  5. Repeat the procedure for the remaining two screws.
    Figure 2. Installing the heat sink
    This figure shows installing the heat sink.
    1. retention screw (4)
    2. heat sink
    3. processor socket
    4. retention screw slot (4)

Next steps

  1. Follow the procedure listed in the After working inside your system section.
  2. While booting, press F2 to enter System Setup and verify that the processor information matches the new system configuration.
  3. Run the system diagnostics to verify that the new processor operates correctly.

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \