Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

Dell PowerEdge R330 Owner's Manual

PDF

Removing the expansion card riser

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

Steps

  1. Lift and rotate the expansion card riser latch to open it.
  2. Holding the touch points, lift the expansion card riser from the riser connector on the system board.
    Figure 1. Removing and installing the expansion card riser
    This figure shows removing and installing the expansion card riser.
    1. expansion card riser
    2. touch point (2)
    3. expansion card latch
    4. guide slot on the chassis
    5. riser connector on the system board
    6. guide pin on the system board
    7. guide slot on the expansion card riser

Next steps

  1. Install the expansion card riser.
  2. Follow the procedure listed in the After working inside your system section.

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \