Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

Dell PowerEdge R330 Owner's Manual

PDF

Installing the hard drive backplane

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

CAUTION: To prevent damage to the control panel flex cable, do not bend the control panel flex cable after it is inserted into the connector.

  1. Follow the safety guidelines listed in Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

Steps

  1. Align the slots on the hard drive backplane with the hooks on the chassis.
  2. Press down the hard drive backplane until the release tabs snap into place.
  3. Connect the SAS/SATA/SSD data, signal, and power cables to the backplane.
    Figure 1. Installing the four 3.5 inch hard drive SAS/SATA backplane
    This figure shows installing the 3.5 inch (x4) SAS/SATA backplane.

    1. guide (2)

    2. hard-drive/SSD backplane

    3. release tab (2)

    4. backplane power cable

    5. backplane signal cable

    6. SAS_A connector on the backplane

    7. hard-drive/SSD connector (4)

    Figure 2. Installing the eight 2.5 inch SAS/SATA backplane
    This figure shows installing the eight 2.5 inch SAS/SATA backplane.
    1. hard-drive/SSD backplane
    2. backplane power cable
    3. backplane signal cable
    4. SAS_A cable connector
    5. release tab (2)
    6. SAS_B cable connector
    7. hard-drive/SSD connector (8)

Next steps

  1. Install the hard drives in their original locations.
  2. Follow the procedure listed in the After working inside your system section.

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \