Dell PowerEdge FC630 Owner's Manual

Disabling a forgotten password

The software security features of sled include a system password and a setup password. The password jumper enables these password features or disables them, and clears any password(s) currently in use.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

Turn off the sled using the operating system commands or the CMC.
Remove the sled from the enclosure to access the jumpers.
Move the jumper on the system-board jumper from pins 1 and 2 to pins 2 and 3.
Install the sled in the enclosure.
Turn on the sled.
When the sled is turn on, power indicator turns on to solid green. Allow the sled to finish booting.
The existing passwords are not disabled (erased) until the system boots with the password jumper on pins 2 and 3.
Turn off the sled using the operating system commands or the CMC.
Remove the sled from the enclosure to access the jumpers.
Move the jumper on the system-board jumper from pins 2 and 3 to pins 1 and 2.
Install the sled in the enclosure.
Turn on the sled.
Assign a new system and/or setup password.

Vitajte

Vitajte v spoločnosti Dell!

Dell PowerEdge FC630 Owner's Manual

Disabling a forgotten password

Ohodnotiť tento obsah