Dell PowerEdge FC630 Owner's Manual

Options to set up iDRAC IP address

You must configure the initial network settings based on your network infrastructure to enable the communication to and from iDRAC. You can set up the IP address by using one of the following interfaces:

Interfaces: Document/Section
iDRAC Settings utility: See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
Dell Deployment Toolkit: See Dell Deployment Toolkit User’s Guide at Dell.com/openmanagemanuals
Dell Lifecycle Controller: See Dell Lifecycle Controller User’s Guide at Dell.com/idracmanuals
CMC Web interface: See Dell Chassis Management Controller Firmware User’s Guide at Dell.com/esmmanuals

You must use the default iDRAC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP for iDRAC.

NOTE: To access iDRAC, ensure that you install the iDRAC port card or connect the network cable to the Ethernet connector 1 on the system board.

NOTE: Ensure that you change the default user name and password after setting up the iDRAC IP address.

Vitajte

Vitajte v spoločnosti Dell!

Dell PowerEdge FC630 Owner's Manual

Options to set up iDRAC IP address

Ohodnotiť tento obsah