- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the stand
- Replacing the stand
- Removing the back cover
- Replacing the back cover
- Removing the rubber feet
- Replacing the rubber feet
- Removing the hard drive
- Replacing the hard drive
- Removing the system-board shield
- Replacing the system-board shield
- Removing the memory module
- Replacing the memory module
- Removing the wireless card
- Replacing the wireless card
- Removing the antennas
- Replacing the antennas
- Removing the solid-state drive/Intel Optane memory module
- Replacing the solid-state drive/Intel Optane memory module
- Removing the media-card reader
- Replacing the media-card reader
- Removing the power-button board
- Replacing the power-button board
- Removing the microphone
- Replacing the microphone
- Removing the camera
- Replacing the camera
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the fan
- Replacing the fan
- Removing the heat sink
- Replacing the heat sink
- Removing the speakers
- Replacing the speakers
- Removing the system board
- Replacing the system board
- Removing the display panel
- Replacing the display panel
- Removing the middle frame
- Replacing the middle frame
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 22-3280 Service Manual
Easel stand
- Insert the tabs on the stand bracket into the slots on the system-board shield and align the screw holes on the stand with the screw holes on the system-board shield.
- Replace the four screws (M3x5) that secure the stand to
the system-board shield.
- Replace the stand cover.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\