- Notes, cautions, and warnings
- Working on Your Computer
- Removing and
Installing Components
- Recommended Tools
- System Overview
- Removing the Battery
- Installing the Battery
- Removing the SD Card
- Installing the SD Card
- Removing the ExpressCard
- Installing the ExpressCard
- Removing the SIM Card
- Installing the SIM Card
- Removing the Display Bezel
- Installing the Display Bezel
- Removing the Display Panel
- Installing the Display Panel
- Removing the Camera
- Installing the Camera
- Removing the Keyboard Trim
- Installing the Keyboard Trim
- Removing the Keyboard
- Installing the Keyboard
- Removing the Base Cover
- Installing the Base Cover
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Memory Module
- Installing the Memory Module
- Removing the WLAN Card
- Installing the WLAN Card
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Display Hinge
- Installing the Display Hinge
- Removing the Palmrest
- Installing the Palmrest
- Removing the Display Assembly
- Installing the Display Assembly
- Removing the ExpressCard Cage
- Installing the ExpressCard Cage
- Removing the System Fan
- Installing the System Fan
- Removing the System Board
- Installing the System Board
- Removing the Heatsink
- Installing the Heatsink
- Removing the I/O Board (Left)
- Installing the I/O Board (Left)
- Removing the I/O Board (Right)
- Installing the I/O Board (Right)
- Removing the Power Connector
- Installing the Power Connector
- Removing the Speakers
- Installing the Speakers
- Removing the Status-Light Board
- Installing the Status-Light Board
- System Setup
- Diagnostics
- Specifications
- Contacting Dell
Dell Latitude E5440 Series Owner's Manual
Installing the System Board
- Align the system board into its original position on the computer.
- Replace and tighten the screws to secure the system board to the computer.
-
Connect the following cables:
- I/O board cable
- power-connector cable
- status-light board cable
- Turn over the computer and connect the coin-cell battery cable and speaker cable to the system board.
-
Install:
- ExpressCard cage
- system fan
- palmrest
- display hinge
- WLAN card
- hard drive
- optical drive
- memory
- keyboard
- keyboard trim
- base cover
- battery
- SD card
- Follow the procedures in After Working Inside Your Computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\